Cookies help us deliver the best experience on our website. By continuing to navigate this site, you agree to the use of analytics and advertising cookies. Click here to learn more.
4 pin adaptor cable (camera) to 5 pin (terminal).Suitable for Agco C1000 monitors, Datatronic4 monitors (including Agco DT-B series) and Challenger C-series monitor.Fits into the 5 pin M12 connector which is located at the back of the arm rest.The cable terminals are moulded plugs and are water and dust resistant.Monitor not included Cable length: 1M
4 pin adaptor cable (camera) to 5 pin (terminal) for Fendt Vario models that locates in the 5 pin M12 connector which is located at the back of the arm rest. The cable terminals are moulded plugs and are water and dust resistant. Cable length: 1M
This 6m cable allows you to connect any wired Sparex Camera system to the TRIMBLE AgGPS FMX, CFX-750 and FM-1000 systems. One cable per camera. Cable length: 6M
Operators use dallas key-style fobs to disable the immobiliser and start the vehicle.Automatically immobilises ignition and starter motor 30 seconds after the ignition is turned Off.Supplied with two dallas keys.LED status indicator.Thatcham 2 approved.Should be installed by an accredited engineer to fulfil Thatcham approval.
Protects your vehicle against unauthorised useAfter its installation, the immobilizer is fully integrated and cannot be recognized by unauthorized personsThe electronic key makes use of contact-free transponder technologyThe transponder (sender and receiver unit)has its own battery-free power supply and is permanently integrated into the mechanical key of the start switchRecovery of a stolen vehicle leads to economic loss and long downtimes. An immobilizer can make theft more difficult.
A8510 Key ProgramingEnsure the immobiliser is disarmed :-1) Switch the ignition ON and OFF three times then back to the ON position within seven seconds.2) The LED on the dashboard will light up signaling the unit is in programming mode.3) Touch an already programmed key onto receptical, the LED will extinguish for one second4) Repeat step 3 for all other keys (Max of 4 touch keys)5) To exit programming switch off the ignition key (unit will automatically exit programming after four keys)NOTE :-1) Programing procedure can only entered with the system disarmed.2) If all keys have been lost the system will need to be replaced
An innovative and convenient way of illuminating and visualising the area around your tractor and implement. A high-power LED flood beam work light with a built-in high-resolution CMOS colour camera to provide clear visibility in the darkest environments and hard to see applications.Fully compatible as an additional camera with S.115175, S.115176 & S.23053 Wired camera systems.See Specifications for product details.
An innovative and convenient way of illuminating and visualising the area around your tractor and implement. A high-power LED flood beam work light with a built-in high-resolution CMOS colour camera to provide clear visibility in the darkest environments and hard to see applications.Fully compatible as an additional camera with S.143668 & S.143669 Wireless camera systems.See Specifications for product details.
A truly wireless camera system with unique combination of battery and strong magnets that allows camera and battery to be moved quick and easy between different machinery.Use when harvesting, baling or reversing. All-you-need-in-a-box.3 years warranty.One camera system – many usage areas Night-vision, water-resistant (IP66)Battery time 20-26 hours
Contains: 1 x 7 TFT-LCD Monitor 800 (RGB) x 480 Resolution, 1 x 1/3 CMOS Camera (Additional camera S.109864) , 1 x Removable sunvisor, 1 x Dual Suction Bracket, 1 x 3m 12V Cigarette plug for monitor, 1 x 3m Power cable for monitor, 1 x ManualMax. no. of cameras: 4 (Max. shown on screen: 2)Max. transmitting distance: 120(M)Temperature range: -20°C to 70°CNight visionCamera viewing angle: 120°IP Rating: IP69KVolts: 8-32V
Used to locate a vehicle on GSM phone with GPS coordinates. (Flight Hardware).Alert the user by SMS when the vehicle leaves the stored position.Small and unnoticed in the eyes of thieves.Water resistant limited Cost (Cost of SMS only) Connects to mobile phone users.Battery powered long time of the vehicle battery.Many functions and settings available to suit the needs of usersInsert Pay As You Go SIM and use internetmaps to monitor propertyTracker will text you latitude and longitudeSend alerts when your property leaves a preset areaOverspeed alertLow battery and low GPS signal alerts
A power bank that connects to your MachineCam, MachineCam HD, MachineCam Mobility, MachineCam MiniA powerful battery (22 000 mAh)Installation takes secondsWaterproof on-off switchRugged, water-resistant design (IP66)3-year warranty (online registration required)Included in the BoxPowerBank with on/off button and integrated magnetMagnet including screws and washers for the cameraCharger 100-240VAC in, 5V 600 mA out with four exchangeable plugs: EU, UK, US and ChinaQuick Install Guide and warranty document
12 VoltE Approved: NoSmall & CompactEmits an audible warning "beep" when vehicle is put in reverse115Db at 1MRequires vehicle to be fitted with reversing lights
24 VoltE Approved: NoSmall & CompactEmits an audible warning "beep" when vehicle is put in reverse115Db at 1MRequires vehicle to be fitted with reversing lights.
12 & 24 VoltE Approved: yesWhen double engaged in reverse gear the alarm cuts out to conform with the restricted hours of use (11.30pm - 7.00am in the UK).Tough, durable and waterproof.Expoxy sealed against mud, water and vibration.Can be steam-cleaned and pressure-hosed.90dB at 1m.
Universal window mounting bracketDesigned for use in machinery, workshops & will adhere to any non porous surface, to hold monitors and contol panel.Reversible bracket
Replacement Monitor 7''Touch button for more convenient operation and longer durability.8 languages available for user operation.Multiple video formats available: PAL / NTSC / AUTO.Automatic backlighting for buttons.Mirror and normal image switch available.TFT LCD monitor with wide view angle and high resolution display.Operates from 10 - 32V. Supports 12V or 24V automobile battery.Image adjustable for Horizontal, Vertical, Mirror and Normal viewing.Supplies power to cameras.Auto switches to back-up, left or right-side camera views.Built-in speaker.13-Pin: 3 cameras inputs.Supplied with: Cable Harness, Remote & Mounting Brackets.
9'' Digital Quad MonitorPicture image may be adjusted for Horizontal, Vertical, Mirror and Normal viewing; characters of the menu will not inverse when set to mirror image.Single, dual, triplex, quad, trefoil, Y-split, PIP1/PIP2/PIP3/H SPLIT/trefoil image available.Touch screen available, can recognize down, left, right side ''swipe'' support two-point touch to realize channel switching.Easy installation and convenient operation, with innovative functionsOne VGA image input, resolution: 800 x 600 (60Hz), 640 x 480(60Hz), one VGA audio inputWith touch screen signal output, under the state of VGA display, when it's connected to computer through USB, you can control the computer through the touch screen
Very good value for money, easy to install - easy to useWired system adapted for the farming environment - robust and practical.Can have up to 2 cameras on one system.Contains: 1 x 7'' TFT-LCD Monitor 800 (RGB) x 480 Resolution, 1 x 1/3 CMOS Camera (Additional camera: S.115188), 1 x 20m Extension Cable, 1 x Removable sunvisor, 1 x Adjustable support, 1 x ManualMax. no. of cameras: 2 (Max. shown on screen: 1)Temperature range: -20°C to 70°CNight visionCamera viewing angle: 120°IP Rating: IP69KVolts: 10-32V
Modern designed switches with touch system, easy to install - easy to useContains: 1 x 7'' TFT-LCD Monitor 800 (RGB) x 480 Resolution, 1 x 1/3 CMOS Camera (Additional camera S.115188), 1 x 20m Extension Cable, 1 x Removable sunvisor, 1 x Adjustable support, 1 x Remote control, 1 x ManualMax. no. of cameras: 3 (Max. shown on screen: 1)Temperature range: -20°C to 70°CNight visionCamera viewing angle: 120°IP Rating: IP69KVolts: 10-32V
Waterproof screen allows installation on cabless machine, easy to install - easy to useWired system adapted for the farming environment - robust & practicalContains: 1 x 7'' TFT-LCD Monitor 800 (RGB) x 480 Resolution, 1 x 1/3 CMOS Camera (Additional camera S.115188), 1 x 20m Extension Cable, 1 x Removable sunvisor, 1 x Adjustable support, 1 x ManualMax. no. of cameras: 2 (Max. shown on screen: 1)Temperature range: -20°C to 70°CNight visionCamera viewing angle: 120°IP Rating: IP69KVolts: 10-32V
9'' Touch Screen, the biggest monitor in the rangeContains: 1 x 9'' TFT-LCD Monitor 800 (RGB) x 480 Resolution, 1 x 1/3 CMOS Camera (Additional camera S.115188), 1 x 20m Extension Cable, 1 x Removable sunvisor, 1 x Adjustable support, 1 x Remote control, 1 x ManualMax. no. of cameras: 4 (Max. shown on screen: 4)Temperature range: -20°C to 70°CNight visionCamera viewing angle: 120°IP Rating: IP69KVolts: 10-32V